platinum molding silicone for grc baluster

platinum molding silicone for grc baluster  

Product Description

APPLICATIONS of platinum molding silicone for grc baluster:

platinum molding silicone for grc baluster could be mainly used for making concrete stones, precision molds, PU molds, resin molds, gypsum casting, candle molding, for life casting, fabric finishing, seal for electronic components and solar circuit board, trademark decoration. etc.

Datasheets of platinum molding silicone for grc baluster

FEATURES of platinum molding silicone for grc baluster:

Two-parts, flowable liquid silicon & curing agent. Can solve the problem of not lighting of the candles and the problem of sticky and white stains on the surface of cement & stone products.

Good tensile strength and tear strength,low shrinkage.

It gets cured at room temperature 25 0C within 5-7 hours.

An exceptional fluidity and good operability, easy to be demolded.

Suitable for pouring methods of operation for small sized molds making.

DESCRIPTION of platinum molding silicone for grc baluster

E620 rtv2 silicone rubber for plaster, cement mold making is generally named two-components silicone rubber, Part A and part B. It features an exceptional fluidity and good operability. The mixing ratio is 1:1,mainly be suitable for making molds application.

Q642 addition cure silicone rubber is mainly used for molds making for food grade products. And it is also develop to solve the problem of not lighting of the candles and the problem of sticky and white stains on the surface of cement & stone products.

OPERRATING INSTRUCTION of platinum molding silicone for grc baluster:

1.Stir part A and part B with right mixing ratio

evenly. And get the mixture for vacuum-

pumping. (If there is no vacuumizer,you can just pour the mixture slowly from the corner so that less bubbles caused).

2. Enclose the product (the original model) with four plastic plates or wooden plates.

3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.

4. Pour the mixture with correct mixing ratio into the model frame.

After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold .

SHELF LIFE of platinum molding silicone for grc baluster:

Twelve (12) months from date of shipment when stored at 24°C in original unopened packages.

PACKAGE of platinum molding silicone for grc baluster

Packed in clean 5kg/pail, 25kg/pail, 200kg/pail.

Any more information abt platinum molding silicone for grc baluster, pls feel free to contact Ford

Mobile: 0086-13076981707

Tel: 0086-755-89212380

Fax: 0086-755-89948030 

Website: www (dot) szrl (dot) net 

Email:hysg(at)szrl(dot)net

Skype: fordhu1101