Self-Rescue Car Emergency Power Device

Multi-USB durable self-rescue ABS Car Emergency Power Device

Safety instructions Car Emergency Power Device
1. It is strictly prohibited to use this product at the place wet or where water is available. 
2. Please keep this product out of the reach of children. 
3. Please do not connect output/input terminal in a reverse way 
4. Please do not throw this product into fire
5. Please do not use this product under high temperature environment (higher than 60℃)
6. Please do not hit/knock/shake this product, otherwise, the structure and internal circuit might be damaged. 
7. Please do not place this product in flammable environment during charging or working of this product. 
8. After the car is stopped, please stop the charging of this product. 
9. Only professional personnel of our company or appointed maintenance agency can disassemble or repair this product. The disassembly or repair by oneself might damage this product. 
10. Only accessories approved by our company can be used, otherwise, this product might be damaged. 
11. Please confirm the output voltage of this product matches with equipment charging voltage before charging digital devices such as mobile phones/laptops/cameras. 

Product Parameters Car Emergency Power Device
Battery: High rate power polymer battery cell 
Capacity: 22000mAh
Input: charging at home 14.8V/1.0A
             Charging in car: 12.6V/1A
Output: Mobile phones/tablets/other digital products: 5.0V/1.0-2.1A 
                Laptops: 20.0V/3A: 20.0V/3A
                 On-board equipment: 12.0V/2.5A
              Automobile startup: 12.0V/200-400A
Charging time: 4-6 hours 
Starting current: 200A
Peak current: 400A
Working temperature: 0-60 C
Product dimension: 234X164X128mm

Standard steps of car jump starter
1. Firmly clamp the anode of automobile storage battery (+) with red clamp and the cathode (-) of the storage battery with black clamp; 
2. Plug the connector of battery cable into (automobile) starting power supply interface of this product. 
3. Try to start the automobile normally. 
4. After the automobile is started, immediately unplug the battery cable connector from starting interface. 
5. Remove red and black clamp (this product will automatically exit start mode)